搜索资源列表
ourdev_480527
- The "AT" or "at" prefix must be set at the beginning of each command line. To terminate a command line enter <CR>. Commands are usually followed by a response that includes.”<CR><LF><response><CR><LF>” Througho
ADM2483
- RS-485 transceiver with electrical data isolation Complies with ANSI TIA/EIA RS-485-A and ISO 8482: 1987(E) 500 kbps data rate Slew rate-limited driver outputs Low power operation: 2.5 mA max Suitable for 5 V or 3 V operations (VDD1)
xc6206
- CMOS Low Power Consumption Dropout Voltage 160V @ 100mA 400mV @ 200mA Output Current more than 250mA <5.0V type> Highly Accurate + 2 Output Voltage Range 1.2V to 5.0V Current Limiter Circuit Built-in Low ESR Ceramic Capaci
Design-of-an-Operational-Amplifier
- disign whit HSPICE: Design and simulate a two stage CMOS operational amplifier shown in the Fig., for these conditions: DC Voltage Gain > 60dB Unity Gain Bandwidth > 70MHz Phase Margin > 50 degrees
power-design
- < 开关电源设计>> TI高级应用经理兼科技委员会的资深委员Robert Kollman编写-Switching Power Supply Design
Computer-Vision
- 机器视觉，双目视觉板卡电路：1> 双目视觉照相机电路图，含红外照明管，可以红外成像的立体双摄像头图像采集电路。2> 长按按键开机/关机电路（类似手机电源按键长按可开机，关机），可以通过程序控制IO关机。3> 锂电池剩余电池电量检测电路。4> 段码式液晶显示屏接口。5> 蜂鸣器驱动电路，采用两个三极管，烧写程序时蜂鸣器不发出噪声。6> 已分析原理图，原理正确，实测电路为有效可靠。-Machine vision, binocular vision circuit
tidud04
- 此 2kW 隔离式双向直流/直流转换器参考设计 (TIDA-00951) 可在 400V 直流总线和 12 - 14 节锂电池组之间进行电力传输，可用于 UPS、电池备份和电力存储等应用。在备用模式下，此参考设计可用作采用 ZVS 技术的有源钳位升压转换器，将电源从 48V 电池传输至 400V 直流总线。当用作电压馈入式全桥电池充电器，从 400V 直流总线为 48V 电池充电时，此参考设计可实现大于 93% 的效率。此参考设计还设有内置直流总线和电池过流保护，并设有过压保护。(for a 2