资源列表
ad
- STC12C5A60S2的AD转换，并送入LCD显示-STC12C5A60S2 the AD converter, and into the LCD display
frequency_divider
- 分频器的编程思路为：32MHZ经过第1次分频变成1KHZ，再经过第2次分频变成100HZ，分别输出两次分频结果。-Divider of programming ideas for: 32MHZ after the first band to become a sub-sub-1KHZ, and then after the 2nd sub-band into a 100HZ, respectively, the results of the output frequency of the two
BDFG1
- 无刷直流电机的仿真程序，用的是M语言进行编写的！-Brushless DC motor simulation program, using the M language for writing it!
LCD
- 基于C语言编程的LCD显示应用程序,简单易懂。-LCD display application based on C programming language.
UART
- UART 串口通讯函数 ，完美收发函数 涵盖单字节发送 多字节数组发送-UART serial communication function, the perfect transceiver functions include single-byte transmit multi-byte array to send
ToggleIO
- msp40F149,说明：拨动P3.4，P3.4内进行异或运算得到软件loop.ACLK= N /，MCLK= SMCLK=默认DCO〜 800K-Descr iption: Toggle P3.4 by xor ing P3.4 inside of a software loop.ACLK= n/a, MCLK= SMCLK= default DCO ~800k
ADC0832_20130805
- ADC0832的嵌入式源代码,AD转换的.-ADC0832 embedded source code, AD conversion.
xiaofangche.c
- 使用C51单片机控制的，用蜂鸣器模拟消防车的C程序。经验证可以 。-Use C51 MCU control, analog fire buzzer C program. Can be proven.
6-bit-digital-frequency-counter
- 6位数显频率计数器6 bit digital frequency counter-6 bit digital frequency counter
12C5A60S2_SPI
- 12C5A60S2单片机SPI程序源文件-12C5A60S2 singlechip SPI source file
KAERMANLVBOCHENGXU
- 卡尔曼滤波小程序，主要应用于平衡小车，这个是子程序，需要的可以自己修改。-Kalman filtering small procedures, mainly used in the balance of the car, this is a subroutine, need to modify.
main
- 单片机开发程序，我个人觉得这个程序写得很不错哟-MCU development program, I personally think that this program is written very good yo