资源列表
DJSQ1
- 倒计时器，设定好时间后，按下启动键，到时间后发出报警声。-Countdown device, set a good time, press the start button to the time after the alarm sound.
C_Key_8255out
- MCU 与8255芯片 括展单片机接口技术-Including the development of chips with 8255 MCU Interface Technology
DS1302
- DS1302时钟超出程序，自己参照资料编的，挺简洁的~-DS1302 clock out process, with reference to data compiled their own, very simple ~
ms
- 检查小车的速度，适用于单机初学者。谢谢。-failed to translate
dingshi
- 单片机内部定时应用，系统启动四位数码管高两位显示-Single-chip internal timing applications, the system starts the upper two four digital display 00
T2RT
- 使用C51单片机 实现采用t2定时计数器完成串口通信 -C51 t2 serial interface communication
LCD-display--51--program
- 具有按键扫描和LCD显示的51单片机程序，适合刚刚接触单片机的朋友们练手-LCD display with push-button scanning and 51 single-chip program, just contact chip for friends to practice hand
display-of-the-clock
- 一个教初学着开发的应用程序，简单易懂，用延迟的方法来计算时间，做一个时钟显示-Teach a beginner with applications developed, easy to understand, to calculate the time delay, to do a clock display
exp3
- 花样流水灯：8个发光二极管D1~D8分别接在单片机P0.0-P0.7端口上，一个开关接在P3.0上。要求输出端口输出“0”时，发光二极管亮。开关闭合时，开始按P0.0+P0.7、P0.1+P0.6、P0.2+P0.5、P0.3+P0.4的顺序依次点亮LED，再按P0.3+P0.4、P0.2+P0.5、P0.1+P0.6、P0.0+P0.7的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-Mood Light water: 8 LEDs D1 ~ D8, respectively, c
m16_uart
- atmega16 串口收发数据程序，亲测通过-atmega16 serial procedures, pro-test by
DS1302
- 基于51单片机，运用DS1302的时间显示C程序-51, use the DS1302 C language program
DS1302-READ-AND-WRITE
- 时钟芯片DS1302例程，程序编写简洁易懂，适合初学者。-the read and write function of DS1302