资源列表
Encode
- 十六位编解码器，时分复用，很好的一个程序-Codec 16, time division multiplexing, a process well
_74Ls164_7SegLED
- 74LS164驱动程序C语言程序，串行数据-C51程序
LCD
- 51单片机C语言的一个128*64LCD常用驱动程序，都是自己写的，测试通过-A single chip C-51 128* 64LCD common drivers are to write their own test through
CPT1.77_7735R
- 此代码为CPT1.77TFT的驱动代码，显示效果达最佳，做LCM模组的朋友可以参考-This code is CPT1.77TFT driver code, showing the effect of the best, so friends can refer to LCM module
spi
- gt21l16系列的spi51单片机驱动，好像2脚和4脚必须加一只100的电阻-gt21l16 series spi51 Microprocessor, like 2 feet and 4 feet must be added the resistance of a 100
16LED
- 基于51单片机的16位LED跑马灯效果的程序直接下载既可使用-Program based on 51 single-chip 16-bit LED Marquee effect directly download either use
adder
- a adder in c++ language
sevenchange
- 一个简单的控制LED七彩渐变的小程序，希望对大家有所帮助。-A simple control LED colorful gradient of small procedures in the hope to all of us help.
int2
- dds芯片AD9850的源代码，能够产生正弦波和方波，但是不能产生三角波，能达到60兆赫，还是给大家一起分享一下。-dds chip AD9850 source code, can produce sine wave. Up to 60 MHz, or to share with you.
eepromFINALcorto
- Basically it waits for a interrupt (push button) and checks if an eeprom 24c64 has FF in all its address then turns a led if true, this is only if the switch in port D is closed, if not, it writes a byte number "i" in the adress number "i" and then v
SA_VHDL-
- a simple serial adder in vhdl, enjoy it
Change_rate
- 控制改变工作频率，可更改，可移植性强，可对多种器件进行操作-Control to change the operating frequency can be changed, portability, and can operate on a variety of devices