资源列表
74HC595_led.rar
- 两片74HC595级联，形成16位并行数据输出。控制8个数码管显示。显示刷新周期为2ms。 单片机只需3个I/O口发送串行数据到74HC595即可。程序用c51编写。,74HC595 2 cascade, the formation of 16-bit parallel data output. Control of 8 digital tube display. Display refresh cycle for 2ms. Only three single-chip I/O port to
AD_tlc1549
- ti公司ad芯片tlc1549的源代码，参考电压为5v,将测得电压转换后发送到串口。-ti ad-chip tlc1549 company' s source code, reference voltage is 5v, the measured voltage is converted and sent to the serial port.
GPIOsimulateUART
- 使用HT46F49E的GPIO+定时器模拟UART功能，默认波特率为9600，可调整，可移植-its a simulation of UART based on GPIO and Timer,it has passed on signal-chip of HT46F49E
dianyabiao
- 51系列单片机，接入AD模块想，实现模数转换，由液晶显示电压-51 computers, access AD module to realize the conversion, the LCD voltage
DelayVarDef
- 基于ATmega128的DHT21温湿度传感器程序延时及变量定义-The DHT21 ATmega128-based program of temperature and humidity sensor time delay, and variable definitions
BREATH
- MSP430G2553开发板实现呼吸灯功能。能够近正弦的方式变化LED灯的亮度。-MSP430G2553 development board realize breathing light function. Nearly sinusoidal manner can change the brightness of LED lights.
4_1
- 利用动态扫描方法在六位数码管上显示出稳定的654321. 时钟频率为11.0592M-Dynamic scan method on six digital tube display a stable 654321. Clock frequency is 11.0592M
I2Czongxian
- 51单片机中，I2C总线（SDA,SCL）的操作程序-I2C bus procedures
TLC549ADC
- 基于单片机ADC转换模块74HC549芯片 单片机外围设备-Microcontroller-based ADC converter module 74HC549 chip microcontroller peripherals
pwm_attachInterrupt
- Arduino 单片机 ，上下沿触发有效，求脉冲宽度。如可以利用它求CO2的浓度（已经实际应用过）-The Arduino microcontroller, up and down along the trigger is valid, and pulse width. If can use it for the concentration of CO2 (have practical application)
PCF8591
- PCF8591是一个单片集成、单独供电、低功耗、8-bit CMOS数据获取器件-PCF8591 is a monolithic integrated, a separate power supply, low-power, 8-bit CMOS data acquisition devices