资源列表
2
- 中断方式实现软件串口通信,基于ht82k95a单片机。-rs_uart
jianpang
- 单片机C语言中矩阵按键前移程序,就是按一次键,向前移一位-Single-chip C-forward button in the matrix program, that is, according to a key, to forward a
bujindianji
- 驱动步进电机，通过定时器中断控制，通过多次运行通过，很稳定-Stepper motor drive, through the timer interrupt control, running through through many times, very stable
liushuideng01
- 彩灯显示：间隔300ms先奇数亮再偶数亮，循环三次；一个灯上下循环三次；两个分别从两边往中间流动三次；再从中间往两边流动三次；8个全部闪烁3次；关闭发光管，程序停止。-Lantern Show: interval 300ms first odd and then even bright light, cycle three times a light cycle up and down three times two separate flow from both sides to the
sd
- 通过动态扫描方式和定时器，实现数码管和LED显示功能-By dynamic scanning mode and timer, Implementation of digital control and LED display
uart
- 51单片机IO口模拟串口程序，已经测试过，接收发数据都正常。稍微修改后也可以应用与其它单片机上。-51 microcontroller IO port analog serial procedures have been tested, receiving hair are normal data. Slight modification can also be applied with other microcontroller.
BUJINMADA
- C51，步进电机加减速，模块化程序，可移植-C51, stepper motor acceleration and deceleration, modular, portable
water-drop
- 采用P0口小灯展示水滴落下的效果，带有拖尾效果。-P0 port using a small light show effects of falling water droplets, with a trailing effect.
D_MUL
- 一个简单的c51的多字节相乘，实用djnz实现的迭代循环-Multi-word multiplies in c51
46-1
- 单片机c语言Keil编程，单片机之间的双机通信。单片机AT89c51。-Keil microcontroller c language programming, dual communication between the microcontroller. SCM AT89c51.
ST7586S-Initial-Code
- LCD driver ST7586S 驱动初始化代码参数.非常有用。-The parameter LCD driver ST7586S driver initialization code. Very useful.
315MHZ_RF_CTRL
- 315M HZ RF发射端控制时序，使用单片机模拟RF编程器。-315M HZ RF transmitter control timing, the use of single-chip analog RF programmer.